Clemă de strângere prin tragere pneumatic oțel de călire brunată 04403-50105
- Automatic pneumatic clamping process
- Can also be used as zero-point clamping system
- Monitoring of the workpiece position possible
- Rapid workpiece connection and disconnection
Unitatea de vânzare
€493.35
plus TVA.
Adăugat la coșul de cumpărături
Designation
Pull clamp
Version 1
pneumatic
Main
material
mild steel
Main
colour
black oxidised
Component
colour
case-hardened
D=diameter
105
Clamping
force
kN
2,5
Clamping force
(clamping by spring force)
N
500
D1
75
D2
63
D3
12
D4
88
D5
G 1/8
H
50
H1
47
H2
35
H3
31
H4
19
H5
10
H6
1,9
Operating
pressure
MPa
0,3 - 1,0
~ CONFLICT MINERALS 3TG status
not yet identified
~ CP65 substance 2 cancer
soots, tars, and mineral oils
~ PFAS free?
not yet identified
~ REACH SVHC-free?
yes
~ RoHS conformity
yes, without exemption
~ TSCA 6(H) conformity
yes
Descriere
Material
Carbon steel.
Version
Clamping element hardened, ground and black oxidised.
Note
Pneumatic pull clamps are used to clamp workpieces and fixtures.
The clamping pin is screwed onto the workpiece or fixture.
Clamping procedure:
Open the clamping element by applying compressed air to the ”open” port.
Close clamping element (for clamping) by applying compressed air to the ”close” port.
The third port (D5) is used to blow out and clean the seating face. It can also be used to get feedback to ensure the workpiece is correctly seated, or to ease lifting the workpiece off after the opening procedure.
The system can also be used as a zero-point clamping system.
The clamping forces indicated are based on 0.5 MPa.
Permissible opposing force = 2x the clamping force of the module.
The clamping pin is screwed onto the workpiece or fixture.
Clamping procedure:
Open the clamping element by applying compressed air to the ”open” port.
Close clamping element (for clamping) by applying compressed air to the ”close” port.
The third port (D5) is used to blow out and clean the seating face. It can also be used to get feedback to ensure the workpiece is correctly seated, or to ease lifting the workpiece off after the opening procedure.
The system can also be used as a zero-point clamping system.
The clamping forces indicated are based on 0.5 MPa.
Permissible opposing force = 2x the clamping force of the module.
Accessory
04403-01 Clamping screws for pneumatic pull chucks.
Notă importantă privind descărcarea modelelor CAD
Pentru a descărca modelele noastre CAD, trebuie mai întâi să vă autentificați. Dacă nu v-ați creat încă un cont, vă rugăm să vă înregistrați la rubrica "Contul meu" (partea dreaptă a ecranului) și să urmați instrucțiunile.
Descoperiți gama de produse norelem
